Building an easy no-cut new deck for a plug and play hot tub
This guide shares how to build an easy new deck for a plug and play hot tub, without cutting any wood! Creates a strong, attractive and cost effective platform that can be used for many different things!
Tools:
- Miter saw if cutting boards to size
Supplies:
- 8 2" x 6" x 8' treated lumber for framing
- 16 5/4" x 6" x 8' treated lumber for top of deck
- 2.5" deck screws (for top)
- 3" deck screws (for frame)
- 8-10 concrete footings
- wooden shims as spacers
Instructions:
How to build an 8' x 8' ground level deck platform.
- Dry-fit 4 frame boards into a square shape, with full front and back boards showing and the side boards tucked inside. Attach corners with screws. Position concrete blocks underneath frame.
- Cut the shape of each block with a half moon edger to remove the sod underneath. Replace blocks, then set frame on blocks.
- Place a level on all four sides to help adjust the footings until the frame sits level.
- Attach the inside 2x6 framing all in one direction (positioned front to back) at a max of 16" apart.
- Place a top deck board on one end of frame positioned left to right. Attach with two screws at each stud possible.
- Use the thick end of wooden shims as spacers before placing the next board. Repeat until deck is covered, measuring each board as you build to ensure they are straight.
- If you don't wish to cut the last board to size, install a board on the opposite end before finishing, then slightly jog the spaces inside to even things out.
- Lightly sand any rugged edges. Allow treated wood to cure before adding further protection. (approx 6 months)
To enhance the deck:
- Place down gravel, sand or landscape fabric to avoid weeds growing through.
Did you try this tutorial?Share it on Instagram and tag @funkyjunkinteriors and include #funkyjunkinteriors so we can check it out!